Every painter has one. The brush that used to come to a needle-fine point and now looks like a tiny frightened broom. It wasn't one big mistake that killed it. It was a hundred small ones: paint creeping up into the metal ferrule, an evening left standing in the water pot, a quick drybrush "just this once" with the good detail brush.
The good news is that looking after miniature paint brushes takes about two minutes a session, and it's the difference between a brush that lasts a few weeks and one that lasts years. That matters most for Kolinsky sable, which costs more and rewards care more than anything else on your desk. Here's how to clean your brushes, how to rescue one that's gone stiff with dried paint, and how to make a sable point last.

Why miniature brushes die young
Almost every ruined brush comes down to one thing: paint drying where it shouldn't. Acrylic paint is a plastic. When it dries in the bristles, and especially up in the ferrule (the metal collar that holds the hairs), it sets like glue. The hairs at the base get pushed apart, the belly of the brush swells, and the tip splits into two or three points that refuse to come back together.
The other killers are mechanical: bending the tip by leaving the brush resting on it, scrubbing with a brush that was never meant to be scrubbed with, and using hot water or harsh solvents on natural hair.
Good habits while you paint
- Only load the front of the brush. Dip the tip, not the whole head. Paint should sit on the front half to two-thirds of the bristles and never reach the ferrule.
- Rinse often. Every few minutes, and every time you change colour. Swirl it gently in the water rather than mashing it against the bottom of the pot.
- Never leave a brush standing in the water pot. Not for a minute, not while you answer the door. The weight of the brush bends the tip, and water creeping into the ferrule loosens the glue that holds the hairs in.
- Use two water pots. One for the first dirty rinse, one for clean water. Your paint stays truer and your brushes come out cleaner.
- Keep a cheap brush for metallics. Metallic paints are full of tiny flakes that lodge in the bristles. A synthetic brush handles them better and won't break your heart.
- Wipe, don't flick. Draw excess paint or water off on a piece of kitchen roll, rolling the brush as you go to keep the point.
How to clean miniature paint brushes after every session
This is the routine that actually saves your brushes. It takes a minute or two at the end of a painting session:
- Rinse in clean, lukewarm water until most of the colour is out. Not hot: heat can soften the glue in the ferrule and is unkind to natural hair.
- Swirl the wet brush over a brush soap to work up a lather. Use light circles, letting the hairs spread naturally rather than pressing them flat.
- Work the lather gently in your palm or with a fingertip, from the ferrule out towards the tip. You'll often see colour come out that you didn't know was there.
- Rinse until the water runs clear. Repeat the soap step if there's still colour coming out.
- Reshape the point with your fingers. A good brush should snap back to a point on its own.
- Dry it flat or tip-up, never tip-down in a pot. If the brush came with a protective cap, only put it back on once the brush is completely dry, and slide it on carefully so it doesn't catch the hairs.
A handy trick for detail brushes: after the final rinse, give the tip a light touch of soap, shape it to a fine point and let it dry like that. The soap sets the shape while it dries. Rinse it out before you next paint.
That's exactly what we made QTRMSTR DECON for. It's a 60g solid brush soap in an aluminium screw-top tin, so it goes in a hobby bag without making a mess. It lifts acrylic out of the bristles, conditions the hair and helps the point come back. It's £8.99 at the time of writing. If you'd like a different brand, our brush and hobby cleaners include the Artis Opus Brush Soap & Conditioner and AK Interactive Natural Brush Condition Fluid.
How to rescue a brush with dried paint in it
So you've found one at the bottom of the pot, stiff as a twig. Don't bin it yet.
- Soap first. If the paint is only slightly dried, a few rounds of brush soap and lukewarm water will often shift it.
- Then a restorer. For properly set acrylic, soak just the bristles (not the ferrule or handle) in a dedicated brush restorer, such as Vallejo Brush Restorer, following the instructions on the bottle. Then work the softened paint out gently with your fingers.
- Always finish with soap. Restorers and cleaners strip the hair. A wash and condition with brush soap afterwards puts it back into shape.
- Be gentler with natural hair. Sable doesn't like long soaks in strong solvents. Short, repeated treatments beat leaving it overnight.
And if the point never comes back? It's not dead, it's been promoted. A brush with a ruined tip makes a perfect glue brush, PVA brush or drybrush for basing. Every painter needs a few of those.
Kolinsky sable or synthetic: which needs what?
Kolinsky sable is natural hair. Each hair has a tiny scaled surface that holds more paint and water, so a sable brush carries a long stroke without drying out and keeps a sharp, springy point. That's why so many display painters use it for eyes, edge highlights and freehand. It's also why it's worth looking after: wash it with soap after every session, keep it away from metallics and drybrushing, and it will hold that point for a very long time.
Synthetic brushes (nylon and similar) are tougher and cheaper. They're ideal for metallics, washes, Contrast and Speedpaint, liners and anything messy. They don't hold quite as much paint, and over time the tip tends to curl, but they shrug off abuse that would finish a sable.
The sensible answer is both: sable for the fine work, synthetic for the rough work, and a dedicated drybrush for scrubbing.
Never drybrush with your good brushes
Drybrushing means scrubbing a nearly-dry brush across raised detail. It's brilliant for fur, armour texture, rocks and bases, and it destroys a pointed brush in minutes. Use a stiff, flat-ended drybrush and treat it as a tool, not an heirloom. Natural goat hair is a good choice: it's soft enough to give a smooth finish and tough enough to survive the scrubbing.
The QTRMSTR Calibre Brush Set
We built our own brush set around exactly that split. The QTRMSTR Calibre Brush Set puts sixteen brushes in one box:
- 4 Kolinsky sable brushes in sizes 00, 0, 1 and 2, for eyes, edge highlights, freehand and anything that needs a sharp point.
- 6 nylon liners in sizes 0000, 000, 3, 4, 5 and 6, for panel lines, edging, controlled layers and metallics.
- 6 goat-hair drybrushes in sizes 2, 4, 6, 8, 10 and 12, for fur, rock, armour, bases and terrain.
The handles are triangular, so they sit comfortably in the fingers and don't roll off the desk. More on the design is on the Calibre page.

Pre-order details, at the time of writing:
- Price: £29.99 Early Bird or £32.99 standard pre-order (RRP £34.99).
- Free DECON: every pre-order comes with a free 60g tin of DECON Brush Soap, added to your basket automatically, click & collect from our Barry shop included.
- Pre-orders close: Sunday 6 December 2026, and the free DECON offer ends with them.
- Expected dispatch: February 2027. You pay when you order, and you can cancel any time before dispatch for a full refund.
Storing your brushes
- Flat in a case or upright, tip up, in a pot or brush rack. Never tip-down.
- Dry before storing. A brush shut away damp in a sealed case can go musty, especially natural hair.
- Keep sable away from moths if it's going to sit unused for a long time. Natural hair is, after all, hair.
- Travel with protection. A brush wallet or tube stops the tips being crushed in a hobby bag.
The honest bit: brush habits to swerve
The water pot as a brush stand. The single most common way good brushes die.
Dipping to the ferrule. Paint you can't see in the ferrule is the paint that splits your tip a month later.
Your sable on metallics. The flakes lodge in the hair and never quite leave.
Hot water. Lukewarm is plenty.
Buying a 20-brush bargain set and expecting points. A handful of good brushes, looked after, beats a fistful of cheap ones that splay after a week. Our painting tips for beginners say the same.
The short version
- While painting: load the front of the brush only, rinse often, never leave it in the water.
- After every session: rinse, soap, lather, rinse until clear, reshape, dry flat or tip-up.
- Detail brushes: set the point with a touch of soap and let it dry.
- Dried paint: soap first, restorer second, soap again to finish.
- Sable: fine work only. No metallics, no drybrushing, no long solvent soaks.
- Drybrushing: a dedicated, stiff drybrush every time.
- Retired brushes: glue, PVA and basing duty.
A good brush is the cheapest upgrade in the hobby that people still manage to waste money on. Rinse it, soap it, point it and keep it out of the water pot, and the brush you buy this year will still be painting eyes the year after next.
Further reading: put those drybrushes to work with our guide to basing Warhammer miniatures, or browse the full paint brush range and the rest of QTRMSTR, our own hobby brand from Barry.
